Landscaping & Gardening

Published on May 10th, 2017 | by admin

0

8 Steps You Shouldn’t Miss When Installing Artificial Grass

Do you know that by having proper installation the maintenance for the artificial grass is lesser? Yes, it is true. So, you really need to ensure the success of the installation to make everything better. Just consider the steps below for you to be guided throughout. Discover what you need to do!

  1. Lay Outing

After purchasing high quality turf from Australian Synthetic Lawns in Sydney, the first step to get started on your lawn installation is lay outing. First, get the total measurement of the surface where you plan to set up the artificial lawn. Plot the strips of lawn on the base and prevent it from dragging. All the turf must be set up with its blades facing the same direction for it to look more natural.

  1. Cutting

If it is necessary to cut the lawn, then do it. You can use a utility knife or a carpet cutter to remove the underside of the lawn. Make sure to cut only short distances one at a time to ensure the same level of its height and gap.

  1. Using carpet Stretcher

It is recommended to stretch the strips of the turf before securing its lock. By, using a carpet stretcher this will be easier. Just press it flat alongside of the lawn with the spines facing downward, then the padded must be kicked using your knee. It will stretch the lawn which will result for the elimination of wrinkles, reduction of its expansion due to heat and assurance that the surface is secured tightly.

  1. Joining the strips of turfs

You must align the strips, fold its edges backward and put a synthetic grass seaming material on its uncovered base. Add an adhesive to cover the used seaming material, fold the strips of the turf back to the seaming material and wait for it to be dry. On the other way, you can use stakes to fasten every 3 inches of it.

  1. Fastening the perimeter

Using 4 to 6 inches galvanized stakes or pins of landscaping anchor are useful in fastening the turf with at least 6 inches’ intervals. Flat it with hammer evenly but avoid creating hollows. You must secure the perimeter, so, for all-out strength, balance the galvanized stakes on both sides.

  1. Adding Infill or ballast

Once the lawn is totally dry, add a layer of particles that will hold the spines standing, balance the turf, and offer cushioning for several activities. Smooth out the surface by using rake until half of the turf blades are covered.

  1. Brushing the turf

Use a power broom to brush the lawn specifically between the parts where infill is applied. Brushing the blades of the turf on an upward direction will make the lawn bloom. Aside from this broom you can also use a carpet rake or a bristled broom made of stiff nylon.

  1. Watering the lawn

For the ballast or infill to settle, it must be watered equally. Make sure that all the area are wet and leave it until it dries. Check for it the next day. For bouncy lawn and too exposed blades of turf, add a layer of infill and rake it again.

The process could be challenging specifically for large artificial lawn so good luck and make it as an achievement. While there’s nothing wrong in doing the installation when you have the knowledge and skills, it still pays to consider the importance of choosing the right synthetic grass installer for a better result.


About the Author



Comments are closed.

Back to Top ↑